0 SKE-5775 Arnott New Rear eRide Electronic Shock Porsche Cayenne (9Y) Excl. GTS

Shock Removal

1 Raise the vehicle.

2 Disable the air suspension system and deflate the applicable air spring per manufacturer’s instructions.

3 Remove the applicable wheel. (Figure 1)

4 Remove fender liner.

5 Locate and disconnect the electrical connector at the top of the shock. (Figure 2)

6 Remove the lower shock bolt. (Figure 3)

7 Remove the two upper shock mount bolts. (Figure 4)

8 Remove the shock from the vehicle. (Figure 5)

9 Removal complete.

eRide Shock Assembly

1 Identify and note the wire color to terminal number on the OE electrical connector to replicate in a later assembly step.

2 Remove the plastic shock cap and wire dust boot from the OE shock. (Figure 6) The OE electrical connector will need to be cut or depinned to do so.

3 Install the plastic cap onto the new Arnott shock. (Figure 7)

4 Install the wire dust boot onto wire and seat into the top mount cap. Use caution to not damage the terminals. (Figures 8, 9)

5 Install the new included wire dust boot onto the new shock wire. (Figure 10)

6 Insert the terminals into the included terminal housing. Match the wire color to the correct terminal number. The tabs on the terminals will be oriented to the inscribed numbers on the terminal housing. It may be necessary to use a pair of needle-nose pliers to gently pull terminals into place to fully engage the locking tabs. Once the terminals are installed, use a small flathead screwdriver to engage the purple lock inside the housing (press down in the orientation shown). (Figures 11, 12)

7 Seat the wire dust boot onto the housing. (Figure 13)

8 Assembly complete.

eRide Shock Installation

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Install the assembled Arnott shock into the vehicle. (Figure 14)

2 Insert the lower bolt to hold the shock in position. Do not tighten at this time. (Figure 15)

3 Install the upper shock bolts. (Figure 16)

4 Use an appropriate jack to raise the wheel hub to normal trim height. Tighten the lower shock bolt and manufacturer’s specifications.

5 Connect the electrical connector at the top of the shock and secure the connector to the plastic top cap. (Figures 17, 18)

6 Tighten all hardware to manufacturer’s specifications.

7 Enable the air suspension and inflate the applicable air spring per manufacturer’s instructions.

8 Install the wheel.

9 Installation complete.