0 SKE-4368 Arnott New Front Electronic eRide Coil-Over Strut Jaguar XJ (X351) w/Comfort 150

AIR STRUT REMOVAL

1 Raise vehicle.

2 Remove front wheels.

3 Remove the sway bar end link nut to disconnect it from the lower control arm. (Figure 1)

4 Remove the upper A-arm ball joint nut and separate the upper A-arm ball joint. (Figure 2)

5 Remove the lower shock mount nut/bolt. (Figure 3)

6 Disconnect the electrical connector from the top of the shock (push on the sides of the connector to release). Tie off wires not needed with coil conversion. (Figure 4)

7 Disconnect the air line from the check valve and the four (4) shock mounting nuts. Tuck un-used airline into suitable location (away from moving parts and sources of heat). (Figure 5)

8 Remove air strut.

eRide STRUT INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Place coil spring onto vehicle. (Figure 6)

2 Install bottom mounting bolt. (Figure 7)

3 Attach the upper A-arm ball joint and install the nut. (Figures 8, 9)

4 Install sway bar end link bolt and nut. (Figures 10, 11)

5 Install top mounting nuts. (Figure 12)

6 Installation complete.