0 SKE-4367 Arnott New Rear Electronic eRide Shock Porsche Panamera (970 Chassis) 150

REAR SHOCK REMOVAL

1 Raise the vehicle.

2 Deflate the applicable air spring per manufacturer’s instructions.

3 Remove the wheel. (Figure 1)

4 Remove the panel inside the luggage compartment and disconnect the PASM connector from the top of the shock. (Figure 2)

5 Disconnect the ride height sensor link. (Figure 3)

6 Remove the sway bar link and lower shock bolt. (Figure 4)

7 Remove the upper shock mount bolts. (Figure 5)

8 Remove the shock from the vehicle. (Figure 6)

9 Removal complete.

REAR eRide SHOCK INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Install the new Arnott shock into the vehicle. (Figure 7)

2 Install the sway bar link and lower shock bolt. Tighten to manufacturer’s specifications. (Figure 8)

3 Install the upper shock mount bolts. Tighten to manufacturer’s specifications. (Figure 9)

4 Reconnect the ride height sensor link. Tighten to manufacturer’s specifications. (Figure 10)

5 Connect the PASM connector the shock rod. (Figure 11)

6 Reinstall the wheel.

7 Reinflate the air spring per manufacturer’s instructions.

8 Installation complete.