0SKE-3736Arnott New Rear Electronic ShockLand Rover Range Rover Sport (L494)150REAR SHOCK REMOVAL
1
Raise vehicle.
2
Remove applicable rear wheel.
3
Deflate air spring on applicable side per manufacturer’s specifications.
4
Remove rear cargo area trim to access upper shock mounting nuts. (FIGURE 1)
5
Disconnect electrical connection. (FIGURE 2)
6
Remove the three (3) top nuts from upper shock mount. (FIGURE 3)
7
Remove the lower shock mount bolt. (FIGURE 4)
8
Remove the shock from vehicle. (FIGURE 5)
9
Removal complete.
REAR SHOCK INSTALLATION
Tighten all nuts and bolts to manufacturer’s specifications during the installation process.
1
Install the shock and lower shock bottom nut and bolt and tighten to manufacturer’s specifications. (FIGURES 6, 7)
2
Install the three (3) top mount nuts and tighten to manufacturer’s specifications. (FIGURE 8)
3
Install the electrical connection. (FIGURE 9)
4
Reassemble the rear cargo area trim.
5
Inflate applicable air spring(s) per manufacturer’s specifications.
6
Reinstall applicable rear wheel.
7
Lower vehicle.
8
Installation complete.