0 SKE-3632 Arnott New Rear Electronic Shock Porsche Macan (95B w/Active Damping) 150

REAR SHOCK REMOVAL

1 Raise the vehicle.

2 Deflate and disable the air suspension system per manufacturer’s instructions.

3 Remove the rear wheel.

4 Remove the wheel well liner. (Figure 1)

5 Disconnect the rear shock’s connector from the vehicle’s harness. (Figures 2, 3)

6 Using an appropriate jack, support the wheel hub and remove the upper shock mount bolts. (Figures 4, 5)

7 Remove the lower shock mount bolt. (Figures 6, 7)

8 Remove the shock from the vehicle. (Figure 8)

9 Removal complete.

REAR SHOCK INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Insert the new shock into the vehicle. (Figure 9)

2 Reinstall the lower shock bolt. (Figure 10, 11)

3 Using an appropriate jack, raise the wheel hub to where the upper shock mount bolts can be installed. (Figures 12, 13)

4 Connect the shock’s connector the vehicle’s harness. (Figures 14, 15)

5 Tighten all hardware to manufacturer’s specifications.

6 Reinstall the wheel well trim.

7 Reinstall the wheel.

8 Inflate the suspension per manufacturer’s instructions.

9 Installation complete.