0 SK-5723 Arnott New Front Coil Strut Assembly Various GM SUVs (GMT1xx) w/Z95 MagneRide & 4WD & SWB Only 200

Front Coil Strut Removal

Your new Arnott coil strut assembly comes with three (3) new top mount nuts and a new electronic bypass coil. All other accessories should be saved during removal for reuse in the installation.

1 Raise the vehicle.

2 Remove the applicable front wheel.

3 Disconnect the electrical connection at the top of the strut. (Figures 1, 2)

4 Remove the bolt that holds the brake line. (Figure 3)

5 Remove the three (3) bolts that hold the ABS line. (Figures 4, 5, 6)

6 Remove the lower sway bar end link nut. (Figure 7)

7 Disconnect the upper control arm. Use leverage to control the tension of the upper control arm bushings. (Figures 8, 9, 10)

8 Remove the two (2) bottom strut bolts. (Figure 11)

9 Remove the three (3) top mount nuts. (Figures 12, 13, 14)

10 Remove the strut from the vehicle. (Figure 15)

11 Removal complete.

Front Coil Strut Installation

Tighten all bolts and nuts to the manufacturer’s specifications.

Different vehicles were used to demonstrate the removal and installation processes.

1 Position the new Arnott strut on the vehicle. (Figure 16)

2 Install the three (3) new top mount nuts provided with your new Arnott strut. (Figures 17, 18, 19)

3 Install the two (2) bottom strut bolts. (Figure 20)

4 Reinstall the upper control arm. (Figures 21, 22, 23)

5 Reinstall the lower sway bar end link nut. (Figures 24, 25)

6 Install the three (3) bolts that hold the ABS line. (Figures 26, 27, 28)

7 Install the bolt that holds the brake line. (Figure 29)

8 Thread the new electronic bypass coil to the strut and connect the electrical coil connection (Figures 30, 31, 32).

9 Install the applicable wheel. (Figures 33, 34)

10 Installation complete.