0 SK-5670 Arnott New Rear Shock Ram 1500 (DT Chassis, w/o Off-Road Package, w/Off-Road Package + HD) 200

Shock Removal

1 Raise the vehicle.

2 Disable the air suspension and deflate the applicable air spring.

3 Remove the applicable wheel. (Figure 1)

4 Use an appropriate jack to lift the rear axle. Remove the top nut from the shock. (Figures 2, 3)

5 Remove the lower shock bolt. (Figure 4)

6 Remove the shock from the vehicle. (Figure 5)

7 Removal complete.

Shock Installation

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Install the new Arnott shock into the vehicle. (Figure 6)

2 Insert the lower shock bolt. Do not tighten at this time. (Figure 7)

3 Install the upper shock nut, using a thread locking compound. (Figure 8)

4 Final tightening for shock mounts should be performed at normal trim height, to manufacturer’s specifications.

5 Reinstall the wheel.

6 Enable the air suspension system and inflate the applicable air spring per manufacturer’s instructions.

7 Lower the vehicle.

8 Installation complete.