0 SK-5639 Arnott New Rear Right Shock Land Rover Range Rover Velar (L560 Chassis, w/Adaptive & Air or Coil Suspension) 150

SHOCK REMOVAL

1 Lift the vehicle.

2 Remove the rear wheel. (Figure 1)

3 Remove the top mount nuts. (Figure 2)

4 Disconnect the wire harness from the top of the shock. (Figure 3)

5 Remove the bottom mount nut; leave the bolt in place for now. (Figure 4)

6 Slightly rotate the top to relieve tension against the studs and pull the shock forward to unmount from the studs. (Figures 5, 6)

7 Remove the bottom mount bolt and remove the shock from the vehicle. (Figure 7)

8 Removal complete.

SHOCK ASSEMBLY

1 Disassemble the OE shock by removing the top nut. Pull the top mount off along with the bump-stop and the shock rod spacer. (Figure 8)

2 Place the bump-stop and shock rod spacer onto the new Arnott shock. Install the OE top mount and secure using the new provided lock nut. (Figures 9, 10)

3 Assembly complete.

SHOCK INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Install the assembled Arnott shock into the vehicle. Insert the bottom mount bolt to hold the shock in place. (Figures 11, 12)

2 Seat the top mount onto the studs using the rotation method from the removal section. (Figure 13)

3 Connect the electrical connector to the provided dummy coil and place the bracket onto the stud. (Figures 14, 15)

4 Install the top mount nuts. (Figure 16)

5 Install the bottom mount nut.

6 Tighten all hardware to manufacturer’s specifications.

7 Reinstall the wheel.

8 Installation complete.