0 SK-4406 Arnott New Rear Shock Toyota Sequoia (XK60 Chassis) 150

REAR REMOVAL

1 Raise the vehicle.

2 Deflate and disable the air suspension per manufacturer’s instructions, if applicable.

3 Remove the applicable wheel. (Figure 1)

4 Un-route and disconnect the AVS connector from the shock. (Figure 2)

5 Remove the upper shock bolt. (Figure 3)

6 Remove the lower shock bolt. (Figures 4, 5)

7 Remove the shock from the vehicle. (Figure 6)

8 Removal complete.

REAR INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Install the new Arnott shock into the vehicle.

2 Install the upper shock bolt. (Figure 7)

3 Install the lower shock bolt. (Figures 8, 9)

4 Attach the provided fir-tree cable tie to the provided coil. Orient the fir-tree to the side with the stand-offs. (Figure 10)

5 Locate the oblong hole on the vehicle’s frame, behind the shock and towards the front of the vehicle. Install the fir-tree retainer into the hole with the connector oriented to the front of the vehicle. (Figures 11, 12)

6 Connect the AVS connector to the coil. (Figure 13)

7 Tighten all hardware to manufacturer’s specifications.

8 Install the wheel.

9 Installation complete.