0 SK-4209 Arnott New Rear Left Shock Lincoln Navigator (U554) 150

REAR SHOCK REMOVAL

1 Raise vehicle and remove the rear left wheel. (Figure 1)

2 Disconnect and unroute electrical connection. (Figures 2, 3)

3 Disconnect ride height sensor bracket from lower control arm. (Figures 4, 5)

4 Remove the bottom shock bolt. (Figures 6, 7)

5 Remove lower control arm bolt. (Figures 8, 9)

6 Remove the three (3) shock top mount nuts. (Figures 10, 11)

7 Pull down the lower control arm and remove shock from the vehicle. (Figure 12)

8 Removal complete.

REAR SHOCK INSTALLATION

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Insert new Arnott shock into vehicle. (Figure 13)

2 Install top mount nuts loosely to hold shock in place. (Figure 14)

3 Reconnect the lower control arm and install the lower control arm bolt. Tighten to manufacturer’s specifications. (Figures 15, 16)

4 Position and reinstall the bottom shock mount bolt. Tighten to manufacturer’s specifications. (Figures 17, 18)

5 Reconnect the ride height sensor bracket to the lower control arm. Tighten to manufacturer’s specifications. (Figures 19, 20)

6 Connect electrical connection to the new shock. (Figures 21, 22)

7 Finish tightening top mount nuts to manufacturer’s specifications. (Figure 23)

8 Reinstall rear left wheel.

9 Lower vehicle.

10 Installation complete.