0 SK-4166 Arnott New Front Left Shock Lincoln Navigator (U554) 200

Front Shock Removal

1 Raise vehicle and remove the front left wheel. (Figure 1)

2 Disconnect and unroute electrical connection. (Figures 2, 3)

3 Remove sway bar end link nut and disconnect. (Figures 4, 5)

4 Remove the two (2) lower shock mount bolts. (Figures 6, 7)

5 Remove the steering rod link nut and disconnect. (Figures 8, 9)

6 Disconnect the upper control arm. (Figures 10, 11)

7 Remove the three (3) top mount nuts. (Figure 12)

8 Remove old shock from the vehicle. (Figure 13)

9 Removal complete.

Front Shock Installation

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

1 Insert new arnott shock into vehicle. (Figure 14)

2 Install the three (3) top mount nuts and tighten to manufacturer’s specifications. (Figure 15)

3 Connect the upper control arm and tighten to manufacturer’s specifications. (Figure 16)

4 Reconnect the steering rod link. Tighten to manufacturer’s specifications. (Figure 17)

5 Install the two (2) lower shock mount bolts. Tighten to manufacturer’s specifications. (Figures 18, 19)

6 Reinstall the sway bar end link and nut. Tighten to manufacturer’s specifications. (Figure 20)

7 Route and reconnect the electrical connection to the shock. (Figures 21, 22)

8 Reinstall the front left wheel.

9 Lower the vehicle.

10 Installation complete.