0 SK-3392 Arnott New Rear Shock Porsche Macan (95B) 200

Rear Shock Removal

1 Raise the vehicle.

2 Deflate and disable the air suspension system in accordance with the manufacturer’s instructions.

3 Remove the applicable rear wheel. (Figure 1)

4 Use an appropriate jack stand under the applicable rear axle. (Figure 2)

5 Disconnect the electrical connector from the top of the shock. (Figures 3, 4)

6 Remove the lower shock bolt. (Figure 5)

7 Remove the two upper shock bolts. (Figure 6)

8 Remove the shock from the vehicle. (Figure 7)

9 Removal complete.

Rear Shock Installation

Tighten all nuts and bolts to the manufacturer’s specifications during the installation process.

1 Position the new Arnott shock onto the vehicle. (Figures 8, 9)

2 Align the bottom shock bolt. (Figure 10)

3 With the shock positioned in the vehicle, attach the supplied electronic bypass coil to the top of the shock with the supplied M8 nut. Apply blue Locktite and torque to 25 Nm. Figures demonstrating this step from outside the vehicle are used for visibility. (Figures 11, 12, 13)

4 Align the two (2) top shock bolts. (Figure 14)

5 Tighten the bottom shock bolt and the two (2) top shock bolts to the manufacturer’s specifications. (Figures 15, 16)

6 Connect the electrical connection. (Figures 17, 18)

7 Reinstall the applicable rear wheel.

8 Enable and inflate the air suspension system in accordance with the manufacturer’s instructions.

9 Installation is complete.