3 Remove the front right wheel and fender well. (Figure 1)

4 Disconnect the rubber hose from the manifold. (Figure 2)

5 Disconnect the air hose from the dryer. (Figure 3)

7 Disconnect the compressor’s air hose. (Figure 5)

8 Disconnect the electrical from the compressor. (Figure 6)

9 Loosen and remove the three (3) bolts and nut from the compressor bracket. (Figures 7, 8, 9)

10 Remove the compressor from the vehicle. (Figure 10)

1 Loosen and remove the three (3) bolts from the compressor bracket and save the two (2) underlying rubber mounts for later use. (Figure 11)

2 Remove the electrical from the compressor bracket. (Figure 12)

3 Loosen and remove the bolt holding the dryer to the compressor. remove the dryer. (Figures 13, 14)

4 Remove the wire clips from the compressor and save them for later use. (Figure 15)

Tighten all nuts and bolts to the manufacturer’s specifications during the assembly process.

1 Secure the wires on the new compressor with the saved wire clips. (Figure 16)

2 Install the dryer onto the compressor. (Figure 17)

4 Reinstall the saved rubber isolators. (Figure 19)

5 Reinstall the three (3) bracket bolts. (Figure 20)

6 Reinstall the electrical onto the bracket. (Figure 21)

Tighten all nuts and bolts to the manufacturer’s specifications during the installation process.

Do not remove the air fitting from the air suspension compressor. Doing so may cause damage or void warranty. Remove the white shipping pin from the new air fitting and insert the air line until fully secure.

The exhaust may be loosened from the rubber isolators to allow for more flexibility during installation.

1 Install the compressor into the vehicle. Reinstall the three (3) bolts. (Figures 22, 23)

3 Reconnect the electrical from the compressor. (Figure 25)

4 Reinstall the compressor’s air hose. (Figure 26)

5 Reinstall the rubber hose onto the manifold. (Figure 27)

6 Reinstall the air hose into the dryer. (Figure 28)

Cracked air springs must be changed to validate the warranty on the compressor

Please read additional warranty information on the back of your invoice

Proper procedure for assessing your air spring's condition

1 Turn off air suspension switch if equipped.

2 Refer to owner's manual for proper lifting techniques and jacking points.

4 Inspect air springs for any type of cracks or excessive wear. Cracks in air springs are evident if they are leaking. This will cause the compressor to overheat from continuous operation.