3 Remove the right front wheel and fender well. (Figure 1)

4 Remove the air intake assembly from the vehicle. (Figure 2)

5 Remove the electrical connector. (Figure 3)

6 Remove the air line from the dryer. (Figure 4)

7 Remove the air line from the compressor. (Figure 5)

The exhaust may be loosened from the rubber isolators to allow more flexibility during removal.

8 Loosen and remove the three bolts from the compressor as illustrated below. (Figures 6, 7, 8)

9 Remove the compressor from the vehicle. (Figure 9)

1 Remove the three bolts from the compressor bracket. (Figure 10)

2 Remove the three rubber isolators from the bracket holes. (Figure 11)

3 Disconnect the electrical connector from the bracket. (Figure 12)

1 Attach the bracket to the compressor using the three bolts and isolators. (Figures 13, 14)

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

Do not remove the air fitting from the air suspension compressor. Doing so may cause damage or void warranty. Remove the white shipping pin from the new air fitting and insert the air line until fully secure.

The exhaust may be loosened from the rubber isolators to allow more flexibility during removal.

1 Install the compressor into the vehicle. Reinstall the three bolts and tighten to manufacturer’s specifications. (Figures 15, 16)

2 Reinstall the electrical connector. (Figure 17)

3 Reconnect the air line to the dryer. (Figure 18)

4 Reconnect the air line to the compressor. (Figure 19)

5 Reinstall the air intake assembly. (Figure 20)

Cracked air springs must be changed to validate the warranty on the compressor

Please read additional warranty information on the back of your invoice

Proper procedure for assessing your air spring’s condition

1 Turn off air suspension switch if equipped.

2 Refer to owner’s manual for proper lifting techniques and jacking points.

4 Inspect air springs for any type of cracks or excessive wear. Cracks in air springs are evident if they are leaking. This will cause the compressor to overheat from continuous operation.