P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR AUDI A8 (D3)
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at
Not to be stored below 5°F (-15°C) or above 122°F (50°C).
Avoid damage to air lines and cables.
Removal and installation is only to be performed by fully qualified personnel.
Use car manufacturer’s diagnostic software.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
AIR SUSPENSION COMPRESSOR REMOVAL
The compressor is located on the vehicles drivers side behind the front bumper. (FIGURE A)
1. Set steering to straight ahead.
3. Remove front left wheel. (FIGURES B, C, D)
4. Locate and remove the screws from the inner fender well. (FIGURE E)
5. Remove inner fender well from vehicle. (FIGURE F)
6. Loosen and remove skid plate fasteners and remove the skid plate to expose vehicle's air suspension compressor. (FIGURES G, H)
7. Locate and disconnect all three electrical plugs from the compressor. (FIGURE I)
8. Locate and remove the air line. Remove the air line fitting from the air hose and discard. (FIGURES J, K)
9. Locate the intake tube. Slide the spring clamp down the hose and disconnect from the compressor. (FIGURES L, M)
10. Locate and remove the three mounting nuts along with the mounting hardware. (FIGURES N, O, P, Q, R)
AIR SUSPENSION COMPRESSOR INSTALLATION
Tighten all nuts and bolts to manufacturer's specifications during the installation process.
Do not remove the air fitting from the air suspension compressor. Doing so may cause damage and/or void warranty.
Remove the white shipping pin from the new air fitting and insert the air line until fully seated.
1. Installation is in reverse order of air suspension compressor removal.
CRACKED AIR SPRINGS MUST BE CHANGED
TO VALIDATE THE WARRANTY ON THE COMPRESSOR
PLEASE READ ADDITIONAL WARRANTY INFORMATION ON THE BACK OF YOUR INVOICE
PROPER PROCEDURE FOR ASSESSING YOUR AIR SPRINGS CONDITION:
1. Turn off air suspension switch if equipped.
2. Refer to owner’s manual for proper lifting techniques and jacking points.
4. Inspect air springs for any type of cracks or excessive wear. Cracks in air springs are evident if
they are leaking. This will cause the compressor to overheat from continuous operation.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email