0 MR-5358 New Front Coil-Over Magnetic Strut Assembly GM Short Wheelbase (4WD), Long Wheelbase (RWD/4WD) SUV’s (K2XL/YG/YC, w/MagneRide) MR-5358 New Front Coil-Over Magnetic Strut Assembly https://bit.ly/4rgXiXx
The product shown in the installation steps below may look different than the part you are installing. The installation steps are the same, and all notices and warnings should be adhered to in the same manner.
AVOID WARNING LIGHTS QUALIFIED MECHANIC MUST PERFORM TRIM HEIGHT RELEARN PROCEDURE
Magnetic Strut Assembly Removal
1 Lift the vehicle.
2 Remove the applicable front wheel. (Figure 1)
3 Unroute and unplug the electrical connection at the top of the strut. (Figures 2, 3)
Do not pull directly on the wires. Move the harness out of the way to avoid pinching it.
4 Remove the three (3) top mount nuts. (Figures 4, 5)
5 Remove the two (2) bottom mount bolts. (Figure 6)
6 Remove the strut assembly from the vehicle. (Figure 7)
7 Removal complete.
The product shown in the installation steps below may look different than the part you are installing. The installation steps are the same, and all notices and warnings should be adhered to in the same manner.
Magnetic Strut Assembly Installation
Tighten all nuts and bolts to the manufacturer’s specifications during the installation process.
1 Position the new Arnott strut assembly into the vehicle from below (Figure 8). Guide the studs through the top mount and align the lower mounting points with the knuckle.
2 Install the three (3) new provided top mount nuts by hand to hold the strut in place. Tighten them snug, but do not torque fully yet. (Figure 9)
3 Install the two (2) new provided bottom mount bolts. (Figure 10)
Start the hardware by hand to avoid cross-threading.
4 Torque the top mount nuts and the bottom mount bolts to the manufacturer’s specifications.
5 Reroute and plug the electrical connection. (Figures 11, 12)
Ensure the connector is fully seated and locked. A loose connection can trigger suspension warning lights.
6 Reinstall the applicable front wheel.
7 Lower the vehicle.
8 Installation complete.
AVOID WARNING LIGHTS QUALIFIED MECHANIC MUST PERFORM TRIM HEIGHT RELEARN PROCEDURE