0 MR-3626 Arnott New Rear Magnetic Shock Various GM SUVs (GMT K2XX, w/MagneRide) MR-3626 Arnott New Rear Magnetic Shock 200 https://bit.ly/4tjoOVs
The product shown in the installation steps below may look different than the part you are installing. The installation steps are the same, and all notices and warnings should be adhered to in the same manner.
Always follow the manufacturer’s instructions and safety protocols for deflating and inflating air suspension components.
Rear Air Shock Removal
1 Set the steering to straight ahead.
2 Lift the vehicle.
3 Remove the applicable rear wheel and wheel well liner. (Figure 1)
4 Locate and carefully remove the air line from the shock by turning the metal clip approximately 90°, then pulling the air line fitting out of the shock. Let it fully deflate before moving on. (Figure 2)
5 Locate and unplug the electrical connector at the top of the shock. Detach the wiring from the clip on the vehicle to free it from the shock body. (Figure 3)
6 Loosen and remove the upper and lower shock mounting nuts. Leave the bolts in place for the moment to support the shock. (Figure 4)
7 Support the axle to relieve pressure on the shock’s mounting points. Remove the upper and lower shock mounting bolts. (Figures 5, 6)
8 Remove the shock from the vehicle. (Figure 7)
The product shown in the installation steps below may look different than the part you are installing. The installation steps are the same, and all notices and warnings should be adhered to in the same manner.
Rear Magnetic Air Shock Installation
Tighten all nuts and bolts to the manufacturer’s specifications during the installation process.
1 Remove the shipping cap. Position the new Arnott magnetic shock into the vehicle, aligning the upper and lower mounting points with the brackets on the body and the axle. (Figures 8, 9)
2 Install the lower and upper shock mounting bolts and nuts. (Figures 10, 11, 12, 13)
Start the hardware by hand to avoid cross-threading.
3 Reconnect the electrical connector and secure the harness back into the clip on the vehicle. (Figure 14)
4 Install the air hose connection by pushing the air line fully into the fitting and rotating the metal clip back into the locked position. (Figure 15)
Ensure the connection is secure and leak-free.
5 Reinstall the wheel well liner and wheel.
6 Lower the vehicle.
7 Installation complete.