0 K-3077 ARNOTT COIL SPRING EBM KIT FOR 2007-2014 VARIOUS LONG WHEELBASE GM SUVs

The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.

GENERAL INFORMATION:

Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at

Not to be stored below 5°F (-15°C) or above 122°F (50°C). Avoid damage to air lines and cables. Removal and installation is only to be performed by fully qualified personnel. Use car manufacturer’s diagnostic software.

Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified in the instructions or in a different sequence.

To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to disconnect your battery.

Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath the vehicle if it is not adequately supported, as serious injuries and death can occur.

ELECTRONIC BYPASS MODULE INSTALLATION

1. Remove side fuse box cover. (FIGURE 01)

2. Remove lower dash hardware and remove lower dash cover. (FIGURES 02, 03, 04, 05, 06)

3. Remove OBD mounting screw and drop the plug down. (FIGURES 07, 08)

4. Remove air conditioning duct. (FIGURE 09)

5. Trim back the plug harness sheath. (FIGURE 10)

6. Using the wiring diagram, match up the wires and splice them together with the T-Tap connectors. (FIGURES 11, 12, 13, 14, 15, 16, 17)

ELECTRONIC BYPASS MODULE FROM PIN# (WIRE/COLOR) VEHICLE'S WIRING HARNESS BLUE 6 (TAN/BLACK) RED 16 (RED/WHITE) GREEN 14 (TAN) BLACK 4 (BLACK)

7. Once all the wires have been connected you will need to secure the EBM under the dash and away from any source of heat and/or any moving parts. (FIGURE 18)

8. Reassemble the dash by reinstalling the air conditioning duct, lower dash cover, lower dash hardware, and side fuse box cover.

9. Remove the cover from the fuse box in the engine compartment. (FIGURE 19)

10. Remove the 30-amp fuse in Location #2 labeled as "ESC/ALC EXH". (FIGURES 20, 21)

If the fuse is not removed a warning light will be displayed in the instrument cluster.

11. Reinstall the fuse box cover.

12. Installation complete.