0C-3544Arnott New Coil Spring Conversion KitLand Rover Range Rover Sport (L320 w/VDS)150FRONT AIR STRUT REMOVAL
Refer to the vehicle service manual for proper air system deflation procedures.
1
Remove front wheel(s) to expose the front air strut(s). (Figures 1, 2)
2
Loosen and remove the three (3) top mounting nuts. (Figure 3)
3
Loosen and remove the lower mount nut. Support the air strut and remove the lower mount bolt. (Figures 4, 5)
4
Carefully lower the air strut to gain access to the air line. Remove the air line fitting from the strut. (Figure 6)
5
Remove the air strut from the vehicle. (Figure 7)
6
Removal complete.
FRONT COILOVER STRUT INSTALLATION
Tighten all nuts and bolts to manufacturer’s specifications during the installation process.
1
Secure the unused air line away from sources of friction and heat. (Figures 8, 9)
2
Install the Arnott coilover strut on the vehicle. (Figure 10)
3
Reinstall the bottom mount bolt and nut. Tighten to manufacturer’s specifications. (Figures 11, 12, 13)
4
Install the three (3) provided top mount nuts and tighten to manufacturer’s specifications. (Figure 14)
5
Front coilover strut installation complete.
REAR AIR STRUT REMOVAL
Refer to the vehicle service manual for proper air system deflation procedures.
1
Raise vehicle and remove rear wheel(s) to expose the rear air strut(s). (Figure 15)
2
Loosen and remove the lower mount nut. Support the air strut and remove the lower mount bolt. (Figures 16, 17)
3
Loosen and remove the three (3) top mount nuts. (Figure 18)
4
Carefully lower the air strut to gain access to the air line. Remove the air line fitting from the strut. (Figure 19)
5
Remove the air strut from the vehicle. (Figure 20)
6
Removal complete.
REAR COILOVER STRUT INSTALLATION
Tighten all nuts and bolts to manufacturer’s specifications during the installation process.
1
Secure the unused air line away from sources of friction and heat. (Figure 21)
2
Install the Arnott coilover strut on the vehicle. (Figure 22)
3
Reinstall the bottom mount bolt and nut. Tighten to manufacturer’s specifications. (Figures 23, 24, 25)
4
Install the three (3) provided top mount nuts and tighten to manufacturer’s specifications. (Figure 26)
5
Front coilover strut installation complete.
ELECTRONIC BYPASS MODULE INSTALLATION
1
Locate the air suspension control module under the driver side dash panel. (Figures 27, 28)
2
Disconnect all harnesses from the suspension control module. The module will remain unplugged. (Figure 29)
3
Using the table and photos below, match the wires and splice them together with the T-Tap connectors. (Figures 30, 31, 32)
From
To
PIN LOCATION
HARNESS
ELECTRONIC BYPASS MODULE
BLACK (GROUND)
BLACK
24
C2321L
RED
LT GREEN/WHITE
20
C0867L
BLUE
YELLOW/BROWN
17
GREEN
YELLOW/BLACK
18
FIGURE 30
4
Connect the EBM module. The exact appearance of the module may vary from the figure below. (Figure 33)
5
Place the EBM in a suitable spot free from friction or pinch points.
6
Disconnect the CVD/VDS control module located behind the rear left interior trim panel in the cargo area. It will remain disconnected. (Figure 34)
7
Installation complete.