0 ASE-4375 Arnott New Rear Right Electronic eRide Strut Porsche Cayenne (92A) ASE-4375 Arnott New Rear Right Electronic eRide Strut
AIR STRUT REMOVAL
1 Open rear cargo hatch and remove applicable side paneling. (Figures 1, 2, 3, 4)
2 Per manufacturer’s specifications for the closed loop air system, bleed the right side air spring.
3 Raise the vehicle and remove the rear right wheel. (Figure 5)
4 Remove the air line. (Figure 6)
5 Disconnect the electrical connection to the strut. (Figure 7)
6 Remove the bottom mount bolt. (Figures 8, 9)
7 Remove the bottom mount of the strut from the wheel carrier. (Figure 10)
8 Remove the four (4) top mount screws. Note the positions of the different length screws for installation. It may be necessary to use a hydraulic jack for assistance. (Figures 11, 12, 13, 14)
9 Remove the strut from the vehicle. (Figures 15, 16)
10 Removal complete.
eRide STRUT INSTALLATION
Tighten all nuts and bolts to manufacturer’s specifications during the installation process.
1 Prepare the new strut by removing the shipping plug from the check valve. (Figure 17)
2 Raise the new strut into position to install on vehicle. (Figure 18)
3 Install the four (4) top mounting bolts to support the strut. Install by hand to avoid cross-threading. Do not tighten yet. (Figure 19)
You will need an additional person to hold the strut from below as you install the top moutning bolts.
4 Use a hydraulic jack or stand for assistance in inserting the lower mount bolt. (Figures 20, 21)
5 Tighten the four (4) top mount bolts to the manufacturer’s specifications. (Figure 22)
6 Tighten the lower mount bolt to manufacturer’s specifications. (Figure 23)
7 Refer to the provided air line TSB or the steps below for the air line installation process.
AIR LINE FITTING REMOVAL
Scratches and/or deep cuts in the air line can result in possible leaks. Inspect the air line before insertion. Air line needs to be replaced if damaged.
AIR LINE INSTALLATION - USING THE NEW AIR LINE FITTING PROVIDED IN THE KIT
8 Connect the electrical connection to the new air strut. (Figure 24)
9 Inflate the vehicle air spring per manufacturer’s specifications, following the procedures for charging the closed loop air system.
10 Reinstall the wheel.
11 Lower the vehicle.
12 Reinstall the rear cargo paneling.
13 Installation complete.