AS-2777
ARNOTT RIGHT FRONT AIR STRUT (SPORT)
FOR AUDI A8 (D3)
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at
Not to be stored below 5°F (-15°C) or above 122°F (50°C).
Avoid damage to air lines and cables.
Removal and installation is only to be performed by fully qualified personnel.
Use car manufacturer’s diagnostic software.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
1. Set steering to straight ahead.
2. Lift vehicle and remove wheel. (FIGURE 10-1)
3. Locate the shock, loosen and remove the air line. Remove the air line fitting from the air hose and discard. Reference technical service bulletin provided with our product for proper fitting usage. (FIGURE 10-2)
4. Loosen and remove the upper control arm bolt. Remove upper arms from spindle assembly. (FIGURES 10-3, 10-4)
5. Loosen and remove the lower shock arm bolts. (FIGURE 10-5)
6. Raise the hood and remove applicable trim paneling to gain access to the front shock towers.
7. Locate and remove wire harness from mounting bracket. (FIGURE 10-6)
8. Disconnect the electrical connection. (FIGURE 10-7)
9. Loosen and remove the three upper shock mounting bolts. (FIGURE 10-8)
10. Now from the bottom side, slide the shock over the lower control arm. Remove shock slowly from mount area. (FIGURE 10-9)
11. Carefully guide the wire through the hole while removing the shock. (FIGURE 10-10)
12. Loosen and remove (4) top mounting bolts from shock. (FIGURE 10-11)
13. Remove the top section. (FIGURE 10-12)
Tighten all nuts and bolts to manufacturer's specifications during the installation process.
Do not remove the air fitting from the air strut. Doing so may cause damage and/or void warranty. Remove the white
shipping pin from the new air fitting and insert the air line until fully seated.
1. Installation is in the reverse order of air strut removal.