0 AH-5697 Arnott Complete Air Helper Kit Ford Transit V363 FWD 200

COMPONENTS

PART NO. DESCRIPTION QTY 29-18449 UPPER BRACKET 2 29-21835 LOWER BRACKET 2 21-20785 HELPER SPRING ACCESSORY KIT 1 29-18647 DOUBLE CONVOLUTED AIR SPRING 2 29-21834 FLAT WASHER, M8 - ZINC PLATED 4 29-21836 COUNTERSUNK SCREW M10 X 45 2 29-17570 M8X1.25 X 20 HEX HEAD SCREW 4 29-21829 COUNTERSUNK SCREW M10 X 1.5 PITCH X 16 4 29-18337 M6 X 8MM HEADLESS SCREW 4 29-18334 ELBOW FITTING 6MM TO 1/4” UNC 2 29-18332 6MM TUBING (BLACK) 5 29-18333 6MM TUBING (YELLOW) 5 29-22250 CONSOLE BRACKET 1 29-22281 CONSOLE ADAPTER FORD 1 AH-5377 ARNOTT WIRELESS AIR HELPER CONTROLLER INCL. HARDWARE 1

REMOVAL

1 Remove serial bump stop. (Figure 1)

2 Remove the bump stop bracket using a wrench with a 13mm hex nut. (Figure 2)

3 Clean the surface by removing all dirt and dust. (Figure 3)

INSTALLATION

1 Mount the upper bracket with the M10 x 45 countersunk screw. Make sure that the cut-out points are to the middle of the axle, 90 degrees towards the driving direction. (Figure 4)

2 Bring the pre-assembled air spring in place. Ensure the air fitting will not be damaged. Hook in the lower bracket to the plate sitting on top of the axle. Make sure the lower bracket accurately fits flat on the plate. The two bolts on the upper plate of the air spring should match the holes in the upper bracket. (Figure 5)

3 Plug in the air line into the fitting (Left Black/Right Yellow). Inflate the air spring manually with the provided inflation valve to max. 2 bar. Check if the air spring is sitting correctly on the lower plate on the axle and verify that the bolts on the upper side of the air spring fit the upper bracket holes.

4 Tighten the headless bolts in the upper bracket with max. 13Nm torque to secure the air spring. Then fixate the lower bracket by tightening the two M8 screws with max. 15 Nm torque. (Figure 6)

5 Route the air line to the installation location of the console. (Figure 7)

CONNECTING CONSOLE AND CONTROLLER

1 Power up the console with the included power cable. Make sure it is fully seated and cannot be pulled out without pressing the retaining clip.

2 Power on the controller with the included 12V power cable or USB-A to USB-C cable. The welcome screen should appear followed by the language selector. (Figures 8, 9)

3 Select the required language. (Figure 10)

4 A screen indicating that the controller is looking for a console will appear. If the controller cannot find the console after 1 minute, move the controller closer to the console. Once the controller found the console, an identification procedure will appear on the display. (Figures 11, 12)

5 The identification procedure starts by automatically turning the compressor on and off multiple times. This verifies that the console you are trying to pair with, it the correct unit. When you hear the console, you can confirm pairing the controller. (Figures 13, 14)

6 The console and controller are now successfully paired. (Figure 15)