0 A-3303 Arnott New Rear Air Spring Fiat Scudo, Peugeot Expert, Citroën Jumpy 200

Air Spring Removal

1 Raise the vehicle.

2 Deflate the applicable air spring using a diagnostic scan tool.

3 Disconnect the air line from the air spring by pushing the collet on the fitting inward and pulling the air line out. (Figure 1)

4 Gently push the lower piston upward and rotate the air spring a quarter turn to remove the air spring from the vehicle. (Figures 2, 3)

5 Removal complete.

Air Spring Installation

Tighten all nuts and bolts to manufacturer’s specifications during the installation process.

Install the new Arnott air spring in its delivered, compressed state.

1 Install the new Arnott air spring by positioning the upper mount and rotating the spring a quarter turn. (Figure 4) Then guide the lower piston into its seat on the control arm. (Figure 5)

2 Remove the shipping pin from the air spring. (Figure 6)

3 Insert the air line into the spring. (Figure 7)

4 Slowly lower the car until the lower piston is fully seated on the control arm. (Figure 8)

5 Use a diagnostic scan tool to inflate the air spring, ensuring the top and bottom mounts are properly seated. (Figure 9)

6 Lower the vehicle completely.

7 Installation complete.