A-2831
ARNOTT REAR AIR SPRING
FOR L322
LAND ROVER RANGE ROVER
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at
Not to be stored below 5°F (-15°C) or above 122°F (50°C).
Avoid damage to air lines and cables.
Removal and installation is only to be performed by fully qualified personnel.
Use car manufacturer’s diagnostic software.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
1. Set the steering to straight ahead.
4. The rear air suspension valve block is located in the right wheel well, removal of the inner
fender well is necessary. (FIGURE A)
5. With the wheel well removed, locate the valve block and drain the air from the air springs by
loosening the yellow and black air lines. (FIGURE B)
6. With all of the air drained from the air springs, remove the lower air spring retention screw
from the bottom control arm. (FIGURE C)
7. Using a pick or similar tool, remove the clip holding the top of the air spring onto the frame.
(FIGURE D)
8. After both upper and lower retention fasteners are removed, you can pull the air spring loose
and disconnect the airline by unscrewing the fitting. Remove the air fitting from the air hose
and discard. (FIGURE E)
9. Removal complete. (FIGURE F)
10. Remove the air line fitting from the air hose and discard. To remove the air line fitting, remove the collet and the
remaining fitting will slide off of air hose. (FIGURE G)
Tighten all nuts and bolts to manufacturer's specifications during the installation process.
Do not remove the air fitting from the air spring. Doing so may cause damage and/or void warranty. Remove the white
shipping pin from the new air fitting and insert the air line until fully seated.
1. Installation is in reverse order of air spring removal.