Arnott Installation Manuals
K-2850
PUMP MOUNTING KIT
2014-PRESENT, FLT W/BAG GAURDS

Congratulations on your purchase of an Arnott® Motorcycle Air Suspension system. This system provides you with the ability to maintain your bike at a constant level regardless of load, resulting in enhanced vehicle ride, handling, and performance. We at Arnott Incorporated are proud to offer a high quality product at the industry’s most competitive pricing. Thank you for your confidence in us and our product.

Proper installation is essential to experience and appreciate the benefits of this system. Please take a moment to review these installation instructions before you begin to install these components on your motorcycle. The removal and installation of air suspension products should only be performed by a fully qualified, ASE Certified, professional.

It is equally important to be aware of all necessary safety measures while installing your new Air Suspension System. This includes proper lifting and immobilizing of the motorcycle and isolation of any stored energy to prevent personal injury or property damage.

"Elevate Your Ride."

K-2850 Pump Mounting Kit

TruAIR

Arnott Industries® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact us by calling +1 321-868-3016 during normal business hours or email techassistance@arnottinc.com (In the EU please call +31 (0)73 7850 580 or email Info@arnotteurope.com).

GENERAL INFORMATION:

Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at www.arnottinc.com

Not to be stored below 5°F (-15°C) or above 122°F (50°C).

Avoid damage to air lines and electrical components.

Removal and installation is only to be performed by fully qualified personnel.

CAUTION: Damage to the motorcycle and air suspension system can be incurred if work is carried out in a manner other than specified in the instructions or in a different sequence.

Each owner or installer is unique, therefore installation of this system can be done many different ways. The mounting locations of the compressor and inflation switch are suggestions by our engineers. If proper wiring guidelines and instructions are followed, relocation of the compressor or switch will neither affect the system operation nor void your warranty.

Adjust air shock pressure as required for desired ride quality to maximize the benefits of your system. Excess pressure will result in a firmer ride, too little pressure will allow the suspension to bottom out.

WARNING: To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to disconnect your battery.

1. Remove the bolt shown below and replace it with the included button head cap screw. (FIGURES 1, 2)

FIGURE 1
FIGURE 1
FIGURE 2
FIGURE 2

2. Remove the two rear bag support bolts below. Replace them with the 2 included hex head bolts and spacers. (FIGURES 3, 4)

FIGURE 3
FIGURE 3
FIGURE 4
FIGURE 4

3. Slide the pump bracket over the new bolts and up against the spacers. Reusing the original or the included nuts snug the pump bracket tightly to the spacers. (FIGURES 5, 6)

FIGURE 5
FIGURE 5
FIGURE 6
FIGURE 6


K-2850 REV 2 10/08/2018