A-2610
ARNOTT GENERATION II
REAR AIR SPRING FOR 2002-2009 BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at
Not to be stored below 5°F (-15°C) or above 122°F (50°C).
Avoid damage to air lines and cables.
Removal and installation is only to be performed by fully qualified personnel.
Use car manufacturer’s diagnostic software.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
1. Set steering to straight ahead.
4. Locate the air compressor behind the right rear wheel.
5. Remove the two lower mounting bolts from the compressor mounting plate. Lift upward on the
compressor assembly and unhook the unit from the frame rail.
6. Deflate rear air spring and pull downward to remove it from the axle. The air spring is held from
turning with a plastic clip on the top of the air spring. You may have to hold the plastic clip down
while rotating the air spring to free it from the upper spring seat.
7. Disconnect the air line from the air spring by pressing down on the steel fitting while pulling outward
on the air line.
8. Carefully remove air spring from the vehicle.
9. Seal off air line to prevent any dirt or grease from entering system.
Tighten all nuts and bolts to manufacturer's specifications during the installation process.
Do not remove the air fitting from the air spring. Doing so may cause damage and/or void warranty. Remove the white shipping pin from the new air fitting and insert the air line until fully seated.
1. Installation is in reverse order of air spring removal.